Last Modified: 11-29-2007 1.6 A
Service Category: Engine/Hybrid System Section: Engine Control
Model Year: 2008 Model: Sequoia Doc ID: RM00000329200AX
Title: 3UR-FE ENGINE CONTROL: ECM: REMOVAL (2008 Sequoia)

REMOVAL

1. REMOVE AIR CLEANER ASSEMBLY 3UR-FE COOLING: WATER PUMP: REMOVAL (2008 Sequoia)+

2. DISCONNECT CONNECTOR HOLDER BLOCK

(a) Remove the 3 bolts and move the connector holder block so that the ECM can be removed in the next step.

3. REMOVE ECM

(a) Raise the 2 levers while pushing the locks on the 2 levers.

NOTICE:

Make sure that the lock lever is raised 90° as shown in the illustration before disconnecting the connectors. Failure to do this may cause the connectors to break.

(b) Disconnect the 2 connectors.

(c) Remove the 4 bolts and ECM.

4. REMOVE GASKET

(a) Peel off the rubber part of the gasket.

(b) Spray gasket remover or equivalent on the remaining tape of the gasket.

NOTICE:

When using gasket remover or equivalent, cover the ECM connector with a cloth.

(c) Use a cutter knife to remove the tape of the gasket.

NOTICE:

Do not damage the ECM seal's surface with the knife.